PRESSING GUIDE
How to heat press a DTF transfer
Bought a transfer from us? Here's how to press it onto a shirt, hoodie or tote in about a minute. A household iron won't get hot or even enough — use a heat press.
1. Pre-press the garment
Place your shirt on the press and press it empty for 3–5 seconds. This removes moisture and wrinkles so the transfer bonds evenly.
2. Position and press
Lay the transfer film-side up where you want the design. Press at 300–320°F (150–160°C) with medium-to-firm pressure for 10–15 seconds. Use a heat-resistant sheet or parchment paper on top.
3. Peel the film
Let it cool for a few seconds, then peel the film back slowly and smoothly. If any part of the design lifts, lay the film back down and press again for 5 seconds.
4. Final press
Cover the design with parchment paper and press once more for 5–10 seconds. This locks in the print and gives it a soft, matte finish.
Care tips
- Wait 24 hours before the first wash.
- Wash inside out, cold water, gentle cycle.
- Hang dry or tumble dry low — never iron directly on the print.

